3D Printing Forum

I downloaded pronterface connected my printer and when I printed the string test was much better I did the flow test whith the command to extrude 100mm and my mark was att 120mm and so I calibrate it. the thing now is that when I start the print, it starts very high. I pressed the command M851 Z0 th...

even with flow settings I did the tests and I could find the sweet spot.. I was either too bad or just not good enough

Yeap I can see that... I tried to find out what estepes are or how to mesure them but I couldn't and also the roll that pulls the fillamets in or our scratches my filament a little bit even if I don't tight the spring..

Hi! I own an Anycubic Chiron and I am experiencing a huge problem with stringing. The filament that I use is from Esun PLA+. I tried a lot of different combinations of temperatures, retraction distances and speeds, layer heights, z-hop on & off and many more. But the result is awful. Can someone...

I have a huge problem with my profile settings and I can't figure it out how to fix it. I bought a transparent filament from REAL and it just get blobby. Some times it prints but when it starts to print in the very first layer the filament doesn't stuck in the build plate creating a mesh. I tried hi...