Page 2 of 2
Re: Cura 2.1.3 crashes at "changelog" opening panel
Posted: August 30th, 2016, 10:47 am
by R.G.
It's an HP s5220F, older small format desktop machine. It's running the built-in Intel GMA 3100 graphics. 4GB memory, dual core processor.
It's slow, but not so slow as 3d printing.
Re: Cura 2.1.3 crashes at "changelog" opening panel
Posted: August 31st, 2016, 1:17 am
by nilrog
That chipset only supports OpenGL 1.4 from the looks of it. So I guess that rules out a lot of "modern" software, sadly.
Re: Cura 2.1.3 crashes at "changelog" opening panel
Posted: August 31st, 2016, 9:56 am
by LePaul
Interesting. I know I had inquired about the graphic requirements of Cura a while back. I was wondering if GPU power was a big factor in how the program worked (pauses, slicing, etc)
Re: Cura 2.1.3 crashes at "changelog" opening panel
Posted: September 1st, 2016, 8:02 am
by nallath
https://ultimaker.com/en/resources/16514-installation <- There already is a list of requirements. It's just not communicated that well.
Website issues need to be sent to the sales team. We (eg; software department) have no control over it.