PTEG
Posted: June 19th, 2020, 3:00 pm
I have a Creator Pro machine and using Flashprint for my programming. I have tried using PTEG, my first set of 3 objects came out fine, the second run had the Teflon tube in the hot end clog up. This happened twice..
Settings:
- ABS material picked in the software (PTEG option not available)
- 230 temp
- speed 50 mm
- spacing between tip and bed same as PLA, used the card that came with the printer
- what should the infill be?
Settings:
- ABS material picked in the software (PTEG option not available)
- 230 temp
- speed 50 mm
- spacing between tip and bed same as PLA, used the card that came with the printer
- what should the infill be?