3D Printing Forum

Hello
I am new to the forum and would need help with the 3dBenchy print. As you can see from the attached photos, I get blobs in the bow onthe boat while the side looks good. Have tried 2 PLA rolls and the result is the same. I use Cura 4.8 as slicer. I have done the esteps calibration for the extruder.
/ Togge

As you might have noted the bumps are on the Bow of the boat.
This could be that you are trying to print a little too fast on the 3dBenchy.

What settings are you using to slice the 3dBenchy

I print the walls 40mm/s

Save your slicer profile and post.

Settings > Profile > Manage Profile > Click
Select the profile you are using Export an attach to next post.

I would think filament moisture only the blobs only occur on beveled edge..

I'm willing to bet that's the randomized z seam

Thank you for helping me. I tried to lower the printspeed to 30mm / s. But there are still blobs in the print. Attach photo and Cura setttings.