3D Printing Forum

I set the offset for print height on the nozzle, but when I print it is to low to the bed. no matter what I make the offset the print head has to be manually raised during print start or its to low. also if (when in manual mode) when z is at 0.000 i can not move below that even though I am not at the hard/soft stop.
Geeetech A20m
Marlin 2.1.x (6/25/2022)(bug fix release)

Well, let me offer this...one of my favorite videos on the Z Offset You didnt mention a BL Touch of probe but i think that machine has one

LePaul wrote: ↑July 1st, 2022, 7:55 pm Well, let me offer this...one of my favorite videos on the Z Offset You didn't mention a BL Touch of the probe but I think that machine has one

this video is the best