What the heck happened here??
Posted: September 6th, 2023, 9:15 am
Hello!!
Super new to resin printing. Just purchased and Anycubic Mono 2 4k.
Ran the test print cube, came out awesome!
I purchased 2 stl files from Hero Forge for 2 DnD minis.
I imported both files into the Anycubic photon workshop. Made certain my files were hollow, added the auto supports and removed 2 or three that had bad placement.
I saved as a new .stl and then sliced, saving as a .pm3n file.
Below are photos, any idea what happened??
Whitney
Super new to resin printing. Just purchased and Anycubic Mono 2 4k.
Ran the test print cube, came out awesome!
I purchased 2 stl files from Hero Forge for 2 DnD minis.
I imported both files into the Anycubic photon workshop. Made certain my files were hollow, added the auto supports and removed 2 or three that had bad placement.
I saved as a new .stl and then sliced, saving as a .pm3n file.
Below are photos, any idea what happened??
Whitney