Adjustable proximity sensor mount
Posted: November 4th, 2024, 10:45 am
One of the things found on my last Pur prints was that my Adjustable proximity sensor mount was not very good the sensor mechanism print, being loose causing sensing inaccuracies.
Today reprinted my Adjustable proximity sensor mount at .2mm layer height to see if I can print it more accurately.
Will have to make some more adjustments to Pur as I am getting layer shifts at 86% print speeds so opted for a slower speed of 72%
It worked out better than expected.
Today reprinted my Adjustable proximity sensor mount at .2mm layer height to see if I can print it more accurately.
Will have to make some more adjustments to Pur as I am getting layer shifts at 86% print speeds so opted for a slower speed of 72%
It worked out better than expected.