3D Printing Forum

Posted: **February 21st, 2017, 2:04 pm**

Posted: **February 21st, 2017, 2:09 pm**

p.s. Where do I find if I am running the latest firmware for my Ultimaker 2+ ? And what's available on the UM site?

Posted: **February 21st, 2017, 2:29 pm**

I highly doubt they will ever update a um2/um2+ firmware.

Posted: **February 21st, 2017, 3:47 pm**

And even if they did...I would use TinkerGnome's FW...just as I use Amedee's FW for my UMO+

Posted: **February 21st, 2017, 4:18 pm**

I do for my UMO (Amedee)

Posted: **February 28th, 2017, 1:30 pm**

I still run stock(upgraded ofcourse) firmware for my UMO+HBK

Isn't there an update from time to time?
Perhaps I should look into Amadee-ware? Any main benefits? I'll look for the topic some day.

Cura 2.4 is out!