How to setup the Octoprint Plugin for Cura!
-
reibuehl
- Reactions:
- Posts: 510
- Joined: February 9th, 2016, 9:56 am
- Location: Stuttgart, Germany
- 3D Printer(s): BambuLab X1C, Ultimaker 2
Re: How to setup the Octoprint Plugin for Cura!
I am tempted to give Octoprint another try after all the promotion that you do for it 
The first time I tried it, it seemed not very useful as I start my prints from SD and OctoPrint couldn't handle that - I do not know if it was the ulti-gcode or the fact that the print was not started by Octoprint itself. With the plugin, it could be a way to get around this limitation if it still exists?!
BTW: The more or less randomly faded in and out music in the video is extremely annoying!
The first time I tried it, it seemed not very useful as I start my prints from SD and OctoPrint couldn't handle that - I do not know if it was the ulti-gcode or the fact that the print was not started by Octoprint itself. With the plugin, it could be a way to get around this limitation if it still exists?!
BTW: The more or less randomly faded in and out music in the video is extremely annoying!
-
LePaul
- Reactions:
- Posts: 4059
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: How to setup the Octoprint Plugin for Cura!
Yeah the "ducking" effect which usually works well seemed to have failed. Next video will be better!