@LePaul will you take over that one too?
Thingiverse going the Ultimaker route - downhill :-(
-
reibuehl
- Reactions:
- Posts: 510
- Joined: February 9th, 2016, 9:56 am
- Location: Stuttgart, Germany
- 3D Printer(s): BambuLab X1C, Ultimaker 2
Thingiverse going the Ultimaker route - downhill :-(
Looks like Thingiverse has pulled an Ultimaker move and released a new revision of their website that is a complete fail! Loading times are horrible - >1min to just open a design.
@LePaul will you take over that one too?
@LePaul will you take over that one too?
-
Roberts_Clif
- Reactions:
- Posts: 1480
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Thingiverse going the Ultimaker route - downhill :-(
Took a few minutes to test the Thingiverse.
It took over a minute to load the main window.
Then it took over 3 minutes to load the window of the model that was selected.
And then another minute to load the download page.
This demotes to 5 minutes to download a simple model.
Second model way over 10 minutes, with disabled Add Blocker Plus thinking it caused problems.
@reibuehl are correct they have messed it up really good.
It took over a minute to load the main window.
Then it took over 3 minutes to load the window of the model that was selected.
And then another minute to load the download page.
This demotes to 5 minutes to download a simple model.
Second model way over 10 minutes, with disabled Add Blocker Plus thinking it caused problems.
@reibuehl are correct they have messed it up really good.
-
LePaul
- Reactions:
- Posts: 4059
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Thingiverse going the Ultimaker route - downhill :-(
Yeah they made a change to their website recently and I don't know if that added to their woes.
Meanwhile MyMiniFactory works fine!
Meanwhile MyMiniFactory works fine!