ColorFabb HT
-
Amedee
- Reactions:
- Posts: 599
- Joined: February 15th, 2016, 11:10 am
- Location: Brussels, Belgium
- 3D Printer(s): UMO / UMO+
- Contact:
Re: ColorFabb HT
I see something coming here...
-
Dim3nsioneer
- Reactions:
- Posts: 221
- Joined: February 19th, 2016, 2:13 pm
- Location: Zurich Area, Switzerland
- 3D Printer(s): Ultimaker Original, 2, 2+, 2 Ext+, 3, S5, Form 2
- Contact:
Re: ColorFabb HT
As I'm a lazy guy: Overhang Test
-
LePaul
- Reactions:
- Posts: 4059
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: ColorFabb HT
Oh good info...can't use that stuff on a UMO though, right? Due to the high temps required?
-
Dim3nsioneer
- Reactions:
- Posts: 221
- Joined: February 19th, 2016, 2:13 pm
- Location: Zurich Area, Switzerland
- 3D Printer(s): Ultimaker Original, 2, 2+, 2 Ext+, 3, S5, Form 2
- Contact:
Re: ColorFabb HT
Well maybe at 250 or 255°C with a TFT UMO coupler, above that the PEEK will probably say goodbye... but nicest results are actually at those temperatures, maybe not the most adherent ones.