A family member is just getting into Bambu P1P, take a look at the results
Just getting into Bambu
-
Roberts_Clif
- Reactions:
- Posts: 1480
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
-
LePaul
- Reactions:
- Posts: 4059
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Just getting into Bambu
Bambu has totally nailed down the ease of entry for 3D printing.
With their sensors all over their machines, they make troubleshooting issues a breeze.
I mean, how many of us searched high and low - here even - for answers to odd print issues?
They've also done a good job of taking the flow rate hassle out for most materials.
There's a few areas I have a few minor issues with - like the default PLA profile only runs my A1 fan at 80% - but my nitpick list is pretty short.
So long as they don't lock people into only their ecosystem - I'm a wee concerned how they ruined a lot of 3rd party products with a recent firmware change.
They've completely wrecked the landscape the Prusa's once ruled. And to me, Prusa's only do two things - over promised and under deliver.
With their sensors all over their machines, they make troubleshooting issues a breeze.
I mean, how many of us searched high and low - here even - for answers to odd print issues?
They've also done a good job of taking the flow rate hassle out for most materials.
There's a few areas I have a few minor issues with - like the default PLA profile only runs my A1 fan at 80% - but my nitpick list is pretty short.
So long as they don't lock people into only their ecosystem - I'm a wee concerned how they ruined a lot of 3rd party products with a recent firmware change.
They've completely wrecked the landscape the Prusa's once ruled. And to me, Prusa's only do two things - over promised and under deliver.